How to assemble your PiJuice Zero Case The PiJuice Zero case is designed to hold your Raspberry Pi Zero, PiJuice Zero pHAT board and a small LiPo battery. It has been uniquely designed to include a small shelf within the case to hold the battery separate from the elements of the boards, whilst also providing […]

PaPiRus Inspirational E Ink Twitter Display This is a quick and easy project to show you how you can utilise the functionality of the PaPiRus display HAT to display inspirational tweets to keep you motivated throughout the day. The project gets the top 20 tweets from twitter handle @quote_motiv and display them one at a […]

How to assemble your HAT Holder for the Nebra IP67 Case In this guide we will show you how to assemble your IP67 HAT Holder into the Nebra IP67 casing. We will also show you where to connect all your HATs on the HAT holder as well as where all the cables should be routed […]

Introduction to LoRa Technology LoRa is short for long range, and it is a long range radio spectrum modulation technique used to send small amounts of data over great distances, typically up to 30km depending on environmental factors, between devices. LoRa technology has been accelerated by the growing IoT industry as well as its unique […]

How to configure your JustBoom IR remote for LibreElec In this guide we are going to show you how to configure your JustBoom IR remote for the latest version of LibreElec. For this guide we will assume that you already have LibreElec up and running on your Raspberry Pi and one of the JustBoom HATs […]

IR Remote Control Support on Raspbian Buster – JustBoom This guide will show you how to get your IR remote control working with the Raspberry Pi using the latest Raspbian Buster OS. Since the release of Buster there have been some significant changes to the way IR is handled, in particular there is now a […]

This quick guide will show you how to connect your RAK831 concentrator module to the Raspberry Pi and configure the software to connect to TTN via Ethernet or Wi-Fi connection. What you need You will need the following hardware components to get started with this guide: Raspberry Pi Model B/3B+ RAK831 and FT2232H LoRa Gateway […]

Set Up JustBoom HAT or pHAT For Mono Output This guide will show you how to merge stereo signals to mono output on either the JustBoom AMP or DAC. We will show you how to configure the ALSA settings using the latest Raspbian Buster OS. When using single speaker configuration with the Raspberry Pi and […]

This project will show you how to use the PiJuice HAT to power separate device other than the Raspberry Pi. In this project we are going to use the PiJuice HAT to power a motor controller board, but you can use to power other devices such as MCU’s. In this project we are going to […]