Chris Rush

Posts: 10 | Featured: 0 | Popular: 5

How to assemble your Media Centre HAT Case

Our media centre HAT case has been design to neatly house your Raspberry Pi and Media Centre HAT whilst still giving you access to the touchscreen and IR on the HAT. It also has some advanced mounting features such as suction cups for mounting on a flat surface and a handy little stand for your […]

Getting Started with the GPIO to FPC Breakout pHAT for Raspberry Pi

The Pi Supply GPIO to FPC Breakout pHAT for the Raspberry Pi makes it possible for you to bring out the 40 pin GPIOs of the Raspberry Pi to a display ZIF/FFC connection, which is more commonly used for displays. This then allows you to connect your own sensors and peripherals etc to the Raspberry […]

Getting Started with the micro:bit LoRa Node

Our IoT micro:bit LoRa Node allows you to create an inexpensive LoRa node, compatible with The Things Network, in conjunction with a BBC micro:bit or other single board computers. This board allows quicker prototyping as it has the LoRa stack on the chip. Add sensors, buttons and more to complete your LoRa network. Uses RAK811 […]

PiJuice Point and Shoot Camera Project

The Point and Shoot Camera Kit uses a combination of the PiJuice HAT, Media Center HAT and Raspberry Pi camera board to create a touch screen standalone camera all housed in the PiJuice Maker Kit Case. This project is designed to highlight the features of the PiJuice HAT as well as the new Media Center […]

How to assemble your PiJuice Maker Kit Case

The PiJuice Maker Kit case is designed to house the Raspberry Pi, PiJuice HAT and Media centre HAT all in one neat little case. With the addition of the media centre HAT it opens up the possibilities to create amazing project that are portable, wireless and easy to interface with using the touchscreen display. We […]

Getting Started with OctoPrint

Getting Started with OctoPrint Pi Supply and OctoPrint have partnered together to bring you the OctoPrint Starter Kit. The OctoPrint Starter Kit gives you full remote access and control of your 3D printer with its comprehensive software. Whats in the Box? Raspberry Pi 3B+ 2.5A Power supply OctoPrint Case micro SD card with OctoPrint software […]

How to connect the Pi Supply PoE HAT to the PiJuice

The PoE HAT allows you to power your Raspberry Pi using an Ethernet connection from your PoE compatible Ethernet switch. Combine this with the PiJuice and you have a complete power solution for you Raspberry Pi. The PoE HAT will not only provide a data connection but also power the Raspberry Pi and charge the […]

How to Setup & Connect your PiJuice battery

We now stock a number of PiJuice batteries with various capacity to suit all of your PiJuice power needs. All the batteries in our store are Lithium Polymer and come with a 3-pin JST connector and a charging protection circuit built-in. Note: Whilst every effort has been made to ensure the safety of these batteries […]

Getting Started with the Pi Supply Switch

The Pi Supply Switch is the solution to all of your Raspberry Pi power management problems. It is an intelligent, ATX style power supply switch for the revolutionary Raspberry Pi computer. It allows you to leave all of the power wires from the wall wart all the way through to the Pi permanently connected with […]

How to assemble your PiJuice Case

This guide will show you how to assemble your PiJuice case with your Raspberry, PiJuice and any additional HAT you may wish to stack, whilst highlighting some of its additional features. The PiJuice Short Case is the prefect enclosure for the PiJuice HAT and the Raspberry Pi. It has been designed so that it can […]