Chris Rush

Posts: 10 | Featured: 0 | Popular: 3

Getting Started with the Nebra AnyBeam HAT

The Nebra AnyBeam HAT is a MEMS laser projector that fits right on top of your Raspberry Pi and uses the GPIO pins with some configuration to project a display. It is the first projector of its kind that has been turned into a HAT board, making it super portable and versatile whilst projecting a […]

Raspberry Pi Compute Module 4

Today October 19th 2020 has seen the long awaited release of the Raspberry Pi Compute module 4. It has come as no surprise since the release of the Raspberry Pi 4 and generally each compute module had followed suit and used the same on-board chip and features. The board uses the same 64-bit quad-core BCM2711 […]

Getting Started with the Traffic pHAT

The Traffic pHAT is a simple LED board that allows users to show the status of all things! It is pre-assembled and ready to go out of the box, just connect it to your Raspberry Pi or Pi Zero and away you go. This is just a quick guide to show you some of the […]

PaPiRus HAT Case Assembly Guide

The PaPiRus HAT is a great way to permanently display text and graphics with its ePaper technology. You can also easily change it’s display or add navigation using its on-board buttons. This is a guide to show you how to assemble the Raspberry Pi and the PaPiRus HAT inside the new an improved case. What […]

How to connect a JustBoom HAT to a Raspberry Pi 1

In this quick guide we are going to show you how to connect a JustBoom HAT to a Raspberry PI 1 board. I’m sure many of you have a Pi 1 board laying around that isn’t getting used much or stored away in a draw somewhere. Most Raspberry Pi expansion boards known as HATs have […]

How to compile the LoRa gateway software for the LoRa gateway HAT

In this tutorial we’ll be going over how to compile the LoRa Gateway Software our LoRa Gateway HAT. This tutorial is targeted towards the Raspberry Pi, however you can also use this as the basis for other SBCs. We also recommend on the Pi that Raspbian is used and cannot provide support for other operating […]

How to connect a GPS module to the LoRa Gateway HAT

This is a quick guide to show you how to connect a UART GPS module to the LoRa Gateway HAT and how to configure it in the Gateway software. What you will need Raspberry Pi computerLoRa Gateway HATUART GPS module Getting Started Step 1 – First you will need to solder the header to the […]

How to assemble the LoRa Gateway HAT

This is a quick guide to show you how to assemble the LoRa Gateway HAT to the Raspberry Pi using the provided mounting hardware. What you need LoRa Gateway HATRaspberry Pi ComputerSmall Philips screwdriverUART GPS module (optional) Getting Started Step 1 – Open up the packet that should include the nylon screws and stand offs […]

How to program the Pi Crust HAT ID EEPROM

How to program the Pi Crust HAT ID EEPROM In this guide we are going to show you how to program the on-board EEPROM chip that is included with the Pi Crust Proto HAT. The ID EEPROM was introduced to the Raspberry Pi HAT specification and tells the Pi how the GPIOs need to be […]

PiJuice Maker Kit Case – 3D Print a High Quality Camera adaptor

If you have one of our cool Maker Kit Cases and you want to attach the new “High Quality Camera” then you are in the right place. We have designed a 3D model of an adaptor for you to 3D print or if you know someone with a printer. The 3D printed camera adaptor simple […]